Auto Calibrating Line Sensor with five pairs of IR transmitter and receiver
This newly developed Auto-calibrating line sensor is super easy to use. Come with five pairs of IR transmitters and receivers, and it can cover line detection of 1cm to 3cm wide, dark color, or bright color line. With one press, it will start “recognizing” the surface under it, calibrating the threshold between dark and bright. It takes 4 to 5 seconds only. After that, it is done, being stored in internal non-vononvolatiley, it will still “recognize” the line even after power off and on again. Come with a connector and wires.
Features
- 5V power
- Five digital outputs representing the logic of 5 IR sensor
- One press to start calibration
- Two press to toggle logic into Dark On mode to sense dark line
- Three press to toggle logic into Bright On mode to sense bright line
- Calibration button for ease of calibration
- Combine with MC40A for line following robot development
- Arduino lover, check out the new 2A motor shield; it comes with a socket for LSS05
- Optional Breakout board to standard 0.1″ pad, BB-2020-08H
Tutorials
http://tutorial.cytron.com.my/2015/01/27/arduino-edubot-using-2amp-motor-driver-shield/
http://tutorial.cytron.com.my/2014/09/12/ciku-2amp-motor-driver-shield/
http://tutorial.cytron.com.my/2016/10/13/how-to-make-your-line-following-robot-faster/
http://tutorial.cytron.com.my/2016/03/16/line-follow-robot/
Reviews
There are no reviews yet.