Smart Motor Driver Dual Channels for two Brush Motor
It is a smart brush motor driver that supports dual channels with 10A continuous current for each channel. Building fighting robot become easy. Choose motor and wheel with a proper battery and connect it to MDDS10 along with a RC controller then you have a robot. With the on board temperature sensor, this smart driver is able to limit the output current stage by stage to prevent itself from overheat and burnt.
Features
- Input Voltage (Motor) 7 – 35VDC
- Single power operation
- Dual Channels, means it can drive two brush motor independently, or mixed.
- Operating modes: RC (RC servo signal), Analog, PWM, simplified and packetized UART
- Support Signed magnitude and Locked Anti-phase in PWM mode
- Two manual/test buttons for each channe
- Two output indicator LEDs for each channel
- Power, Error indicator, RUN status (Left and Right) LEDs
- On board reset button to restart the MCU after changing operation mode
- Temperature feedback for current limit and prevent overheating of MOSFET
- Support up to 10A continuous current at room temperature
- Support up to 30A peak for 1 second. Current will be limited as temperature raises
- Suitable for combat or sumo robot
- 16KHz switching frequency for quiet operation
- On board switching voltage regulator for higher power efficiency
- Battery low voltage monitoring mode
- We have tried this driver with single power window motor at 24V, full load without smoke coming out
- NO polarity protection, please double check the power input connection
- Dimension: 66.8mm x 101.09mm
Reviews
There are no reviews yet.