AudioB I2S Bluetooth Digital Audio Receiver Module – U.FL

$13.15

If you want to build a digital Bluetooth amplifier board, the AudioB I2S Bluetooth audio receiver module is a good choice for your project. This is a Bluetooth 5.0 stereo receiver module with I2S digital output and a music resampling frequency of 48KHz. It supports Apt-X and is based on QCC3008. We breakout pins to 2×10 2mm spaced male pins. You can easily integrate it into your project. This module has a U.FL connector. You can connect an external 2.4G antenna using a U.FL to SMA cable.

AudioB I2S Bluetooth Digital Audio Receiver Module – U.FL

If you want to build a digital Bluetooth amplifier board, the AudioB I2S Bluetooth audio receiver module is a good choice for your project. This is a Bluetooth 5.0 stereo receiver module with I2S digital output and a music resampling frequency of 48KHz. It supports Apt-X and is based on QCC3008. We breakout pins to 2×10 2mm spaced male pins. You can easily integrate it into your project. This module has a U.FL connector. You can connect an external 2.4G antenna using a U.FL to SMA cable.

If you want a demo board, please buy our TSA7010 Digital Bluetooth Audio Receiver. It’s an AudioB I2S module + DAC board.

The module’s PINs 7, 8, 9, and 10 are I2S output pins with an I2S voltage of 1.8V.

  1. 7 – GND
  2. 8 – BCK: I2S synchronous data clock. It’s a 2.304MHz square wave signal.
  3. 9 – SD: I2S synchronous data output.
  4. 10 – LRCK: I2S word select, 48KHz. 1 – Left channel data, 0 – Right channel data.
  5. Setting switch: We set it to I2S in the normal state. When you need to program the module, set it to SPI.

Note: 

  • You need to set the on-board switch to SPI when you program the module.
  • If you want to use this module on our digital audio amplifier boards, change it from an I2S master to an I2S slave.

Note:

  1. Quick press S2 to switch to the previous song; long press to reduce the volume.
  2. Quick press S3 to switch to the next song; long press to increase the volume.
  3. Press S1 to play or pause.
  4. If there is an audio output, the MUTE pin will be at a high level; otherwise, it will be at a low level.

Features:

  • Bluetooth 5.0
  • I2S digital output
  • Sampling Rate: 48KHz
  • Bit per Sample: 16-bit
  • Left Justified
  • Justified Data 1-bit delay
  • Apt-X supported
  • Low power consumption: 5mA@5V
  • HFP V1.6
  • HSP V1.2
  • A2DP V1.2
  • AVRCP v1.4
  • Support for smartphone applications (APPs)
More From: