AudioB I2S Bluetooth Digital Audio Receiver Module – U.FL
If you want to build a digital Bluetooth amplifier board, the AudioB I2S Bluetooth audio receiver module is a good choice for your project. This is a Bluetooth 5.0 stereo receiver module with I2S digital output and a music resampling frequency of 48KHz. It supports Apt-X and is based on QCC3008. We breakout pins to 2×10 2mm spaced male pins. You can easily integrate it into your project. This module has a U.FL connector. You can connect an external 2.4G antenna using a U.FL to SMA cable.
If you want a demo board, please buy our TSA7010 Digital Bluetooth Audio Receiver. It’s an AudioB I2S module + DAC board.
The module’s PINs 7, 8, 9, and 10 are I2S output pins with an I2S voltage of 1.8V.
- 7 – GND
- 8 – BCK: I2S synchronous data clock. It’s a 2.304MHz square wave signal.
- 9 – SD: I2S synchronous data output.
- 10 – LRCK: I2S word select, 48KHz. 1 – Left channel data, 0 – Right channel data.
- Setting switch: We set it to I2S in the normal state. When you need to program the module, set it to SPI.
Note:Â
- You need to set the on-board switch to SPI when you program the module.
- If you want to use this module on our digital audio amplifier boards, change it from an I2S master to an I2S slave.
Note:
- Quick press S2 to switch to the previous song; long press to reduce the volume.
- Quick press S3 to switch to the next song; long press to increase the volume.
- Press S1 to play or pause.
- If there is an audio output, the MUTE pin will be at a high level; otherwise, it will be at a low level.
Features:
- Bluetooth 5.0
- I2S digital output
- Sampling Rate: 48KHz
- Bit per Sample: 16-bit
- Left Justified
- Justified Data 1-bit delay
- Apt-X supported
- Low power consumption: 5mA@5V
- HFP V1.6
- HSP V1.2
- A2DP V1.2
- AVRCP v1.4
- Support for smartphone applications (APPs)
Reviews
There are no reviews yet.